Search results

What front shocks are everyone using

I'm confused about what helmet is needed to drag race a malibu that runs 11.9 in1/4 mile. Sa dot sa m2020 What is for motorcycles and what is nhra required for cars. What dates am I looking for that won't expire for a couple years. I don't race full time and maybe once or twice a year. Who sells...

I'm confused about what helmet is needed to drag race a malibu that runs 11.9 in1/4 mile. Sa dot sa m2020 What is for motorcycles and what is nhra required for cars. What dates am I looking for that won't expire for a couple years. I don't race full time and maybe once or twice a year. Who...

Thanks, good ideas

That's kinda what I figured I'd do but I can't find any photos to build from people that have experience with them.

Yes I'm fine with that. Where do I buy one or how do I make one

Did you figure it out ?

Does anyone sell a pull back rod for a stock pedal in a malibu. My last run last night my throttle got stuck and I had a hard time getting the pedal back. Show me what you guys are using

Do the wires pull out of the plug and replug into different location numbers as directed in the instructions on this site?

Did you ever figure it out, I'm planning on the swap too

Thanks, Something to think about

my 60's are at best 1.758 VOODOO CAM Hydraulic Flat Tappet, Advertised Duration 284/292, Lift .525/.546, protopline heads 200 cc runners/68cc chambers, 2.05/1.60 valves 10.5 compression 3000 stall B&M convertor victor jr mech pump

do i need two fuel pumps , one just for nitrous ? I have the stock gas tank too no sump.

thanks

Thats some of the basic questions i need schooled on. I have a mech pump now, victor series.

I have a 383 stroker in my malibu that is built fairly better than stock, steel crank forged pistons and eagle rods, 373 gears and 3000 stall, on 275 mt drag radials. I run mid 12's and am trying to tune the suspension better to get it low 12's or 11.99 on engine alone but I would like to for...

Thanks Thats kinda what I was thinking too but wondered if someone had been down that road before and had a better idea. thanks for the reply. Yes i like to have it built to take what ever I throw at it,lol.

I need a spare wheel for the trunk in case of a flat since i drive on the street mostly, problem is I have 5/8" lugs on the back and stock 7/16" on the front. A stock wheel hole is smaller than 5/8 ,I have a ralley wheel from a vette I was thinking maybe drill it out slightly to fit and use...

welcome to the site.

wow berea, thats where my familys from. big hill.