This came with my Blueprint engine
Valve Adjustment
⦁ A good place to start is rotate crankshaft until mark on harmonic balancer aligns with center or ``O'' mark on timing tab, attached to crankcase front cover, and piston of No. 1 cylinder is at top dead center of compression stroke. This may...
Here is Mickey Thompsons ballpark suggestions. If you scroll down it shows they recommend 1# change at a time with radials.
I found more is better. I run 18 with my 27.5 " 255 60 x 15 ET R. my car weighs 3500 with me in it running mid 12s w a 1.8, 60 . That is at my track in cooler weather...
I have the Summit 3 way front and back. I understand they are as good as the C.E. Work fine in my combo ( see sig.). I am working on my air bag pressures and tire pressure. So far a 1.76 -60 is my best with a car that weighs 3600 with me in it. Stock rear control arms and springs, no bracing.
\:D/ Leak is fixed. dancin_banana.gif Thank God!
A buddy put in some of those one piece bearing and seals . I drove about 45 miles home . It sat for an hour, all dry. The last seal change leaked right away. Never sealed at all.
Back to my regularly scheduled program. :mrgreen:
Thanks...
Hi Ed,
I have been thinking about them, but I read they get worn fast driving on the street. I think it was on Mosers' site. They are for straight line only. it said. I have to look into it more.
Thanks Marc.
A guy is trying to redo the seal a second time. It leaked worse after the first attempt .
I told him about the vent.
If this doesn't work I may try one of those axle saver one piece bearing and seal and a new axle. I hope not. I'm in this thing too much already.
Thanks that's a big help. Can you give me a little more detail on how you modded the vent? I never even noticed it. I only have it a couple of months..
My GN rear is leaking a lot on the right tube end. We replaced the seals yesterday and it's leaking worse. It has 28 spline axles. Tubes seem straight axles went in and out easily.
Are there different seal part numbers for different year GNs or different spline axles.
Thanks
Maybe someday Tommy. Have lots of odds and ends. Just did shocks , Figuring out my jetting. All the little things. Hope to do better Tuesday night at Atco. Going over my carb I noticed I was not getting full throttle, a simple cable adjust but I over looked it. #-o
You were right on. Thanks.
I bought some Summit 90-10 front and adjustable rears .I set the rears at 50-50. Right front and right rear that came with the car were bad. The right rear did nothing at all. i'm sure that wasn't helping my 60'.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.