I was originally going to use the factor harness but opted to go the route of the Holley set-up. My factors though came down to cost vs stock modifications and purchasing a program to change the tunes on a factory ECM. Cost did not have much difference for me so I went with the Holley ECM and...
Whoops. I didn't catch the post was a year old! I wonder why it was at the top or this area just doesn't see much action. Lol. So did you use a eBay gt45? And how did u mount your IC. I just started collecting parts
Thanks. Are you supporting the turbo from a bracket on the frame or did you use a triangulated support from the block? I see that you have a pressure regulator on the new set-up, what did you do when you ran the stock truck intake and fuel rails? I picked up a GT45 knock off someone had with the...
Any one have any photos of their set-ups? And for those of you running an intercooler, is it mounted in the engine bay or behind the grill? did u use a GN set-up to make it work?
So did the backseat actually bolt up back there? Or did you have to do some trimming etc to make it fit? What type of Hyundai? The seats look slick and the car is looking good!
Well I unbolted it all back to the rear tire. For Me that is where it disappears but frame off would be a breeze. If I were to jack up the body how many body bolts would I need to unbolt? I have new bushings to put in anyway so I could start that.
A few years ago I bought the ClassicTube stainless brake line kit for the car. I am finally installing on my car and I have the front to rear line to add. My line was replaced about 10 years ago but it was made out of 2 lines spliced together. I have debated leaving it there but I prefer one...
I have not heard about removing the bump stops. I know the spindle is a direct swap so not sure why you would need to remove the bump stop. I actually just put the blazer set-up on my car but its still in the air and no trans so I haven't driven it yet. I snagged both sides from a yard for $90...
I have a dash that develop a few small splits and I was going to repair it. I picked up the SEM vinyl repair and the grain pads. I am wondering what material to use to slip under the vinyl to apply the product to so it isn't absorbed into the foam? I am not worried about the color since I just...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.