SBC 400 .60 OVER ???"S

[dickeymoore]

I have a chance to get a SBC 400(509) shortblock that is .60 and know that .60 over is not GOOD but I can get the shortblock for dirt cheap and it ran good,I was wondering if I get the shortblock could I use the 400 crank and the bearings or how can I tell what size bearings I need for this crank to install it,the engine was recently rebuilted?THANKS

 

[SSedan64]

Not sure what you're asking.
Do you just want to freshen it up while it's apart?
Crank should be stamped if it's been ground, 010, 020 etc.. but, it's best to measure the Main & Rod journals with a Micrometer. Bearings will also have #'s on them indicating size.