Tube front frame section

10secBu

MalibuRacing Junkie
May 21, 2003
4,284
0
36
Westminster, MD
I think it's a nice looking setup. If you race a specific class you need to check to see if it is legal. I know the class I used to race it was not legal.
 

bbc-olds

Frequent Racer
Thread starter
Jun 7, 2008
542
2
18
Malin OR
No specific class. Bracket racing and c gas/9.60 index racing. Looking to take weight out of the car without going to glass.
 

TRZ Motorsports

Frequent Racer
Nov 8, 2005
362
0
0
Orlando, FL
www.trzmotorsports.com
We've sold a few of those and also installed 1 or 2. Fairly easy install and pretty straight forward. People seem to like them. I can't remember what the actual weight savings was, but it's a pretty good amount.
 

bbc-olds

Frequent Racer
Thread starter
Jun 7, 2008
542
2
18
Malin OR
TRZ Motorsports said:
We've sold a few of those and also installed 1 or 2. Fairly easy install and pretty straight forward. People seem to like them. I can't remember what the actual weight savings was, but it's a pretty good amount.

Currently have one of your R&P steering setups in my car. Will it work with this frame. Tie rods look longer due to the angle they run out of the center.

Thanks
 

TRZ Motorsports

Frequent Racer
Nov 8, 2005
362
0
0
Orlando, FL
www.trzmotorsports.com
You're correct. You would just need new longer tie rod adjusters and would have to re-do the steering shaft. Same rack kit and all though.
 

MalibuRacing.com Gear

Stickers & Shirts!!