Pinion shaft on a rack n pinion

Discuss how to make your car hook, bounce or hug corners.

Moderator: Moderators

Post Reply
Amateur Racer
Posts: 286
Joined: Mon Oct 04, 2004 10:58 am
Location: Hatboro, Pa.

Pinion shaft on a rack n pinion

Post by CpTech » Mon Sep 12, 2016 10:44 am

Hi Folks, this is more of a general rack n pinion question vs specific to the gbody. Is there a way to either shorten the original pinion shaft, or purchase a shorter pinion shaft for a rack ?? In this case, it's a pinto rack. The splines are at the top of the shaft, with no splines at the bottom. If the shaft was shorter, it would give me a better angle and more room.

Thanks in advance for any help.
If you're gunna be a a Grizzly !!

Post Reply