Search results

As long as you don't run slicks or drag radials it will and also use a girdle cover I been doing it for years!!!

GLOCK 29 with Underwood extreme penetrators

I just got the setup from a g body with a 200r4 column shifter and it works getting all gears with a 700r4 transmission using coljmn shifter

GLOCK 29 EVERYDAY!!!!

Yep I have been running the Comp Cams retro hydraulic roller lifters for years and they all make noise

What happened to classified ads on Malibu racing.com?

I'm installing some more emergency brake cables on my G body and the brake cables that I have requires the Cotter PIN fit to secure them with the other one has the snap rings to secure them does anyone know where I can get the cotter pins that holds this Cable in the housing ?THANKS

I have a 1985 8.5 Grand National Rear End that has 456 gears and pinion in it and I want to change the gears and pinion out to 373 what is the best gear and pinion maker and part number for this application it will be in a daily driver?THANKS

I have a 1980 Chevy Monte Carlo with a small block Chevy 400 and a 700 R4 Transmission in it with a 7.5 rear end and I'm thinking replacing the rear end with a 8.5 Grand National Rear End how long does the drive shaft has to be with the 8.5 rear end?THANKS

Yeah I think the trans was already shot I bought it used so I'm getting a brand new one rebuilt from Mad Dog transmission

I'm using a 1600 stall not 2600 stall with 241 gears my bad

Yeah I know a gear swap will be better but this my daily driver

So don't use the 1600 stall converter with the 241 gears,a stock converter is like 1300 rpm? THANKS

Comp cams 12-422-8 says it will work with stock converter so I guess 2600 stall will be fine

Yeah I'm going with a 1600 stall and rebuild transmission

, yeah I figured the transmission is just shot after I pulled up the pan and there is a lot of black and gray stuff in it so I'm just going to get a rebuilt transmission

Cam will work with stock converter

I have a 1980 Chevy Monte Carlo with a 700 R4 transmission and or TCI Saturday Night Special torque converter 2,000 RPM stall with stock 241 gears in the rearend or 2 Series gears the car drived and shift fine driving in normal operation but if you stomp on it from a standstill it will pull...

I recently bought a complete small block Chevy 400 engine that is supposed to run but when I pull the valve covers there is a lot of gunk in the head what's the best way to remove the gunk from the heads I have heard things like kerosene or automatic transmission fluid what's the procedure and...

I have a small block Chevy 400 with Edelbrock RPM performer heads with hedman headers 68600 shortie headers what header gaskets are the best to use I have the Percy's 66011 will this work good with no leaks and is there anything that I need to put on them to make them seal or just install them...