I've been looking at Wiseco, Probe, and SRP for my soon to be turbo'd 355. I have AFR 190 heads milled to 67 CC. I'm looking at a 8.5 to 8.9 compression ratio, 5.7 forged Crower rods. I'm also looking at hydraulic roller cams. I've narrowed the brands down to Howards, Bullet, and Lunati, just not sure of specs yet. Any one use these companies grinds for their application. All suggestions and comments are welcome.
I'm done,
Kino
Hey Aaron Rodgers where is your belt now???
I'm done,
Kino
Hey Aaron Rodgers where is your belt now???