need a reliable motor for street

[blown 78]

Im looking for a good combo for a street motor. I have a fresh 350 short block. What cam heads intake and carb would make for a good street motor. Its going to be a daily driver. Might hit the strip 3 or 4 times a year if that and it will be drivin far distances the transmission is either going to be a 4 speed stick of a turbo 350 and the rear will more than likly have 342s. Thanks for any input

 

[holtjohn]

Vortec heads, XE262H or XE268h Comp cam, Performer RPM intake, 1.6 roller rockers, 650 to 700cfm carb of your choice, and a good set of headers. I myself love the Comp XE268h cam but it can't be used with stock valve spring Vortec heads, but if you get the springs fixed for more lift the I would run it if not the the Comp XE262H is a great street cam that doesnt give up much power to the XE268H. If you have some type of flat tops that yeild a comp. ratio of 9.25 to 10.0 then this should be around a 400 hp setup that has great street manners. Just my .02

 

[blown 78]

Would this be a good kit? I already have a new in the box 650 edelbrock.
http://store.summitracing.com/partdetail.asp?part=CMB%2D08%2D0037&view=128&N=700+115

 

[holtjohn]

Ya that isnt a bad kit/combo, but the cam that comes in that kit is kinda big for a street motor. It will need a 2500 stall behind it, but not a bad kit.

 

[blown 78]

I am going to be running a muncie 4 speed i just picked up no converter for me

 

[Anonymous]

Would this be a good kit? I already have a new in the box 650 edelbrock.
http://store.summitracing.com/partdetail.asp?part=CMB%2D08%2D0037&view=128&N=700+115

knock off of the edelbrock power rpm package good setup

 

[blown 78]

That kit i posted uses all edel brock stuff and is pretty much the same as the edelbrok power pack but 200 cheaper. Also do you think a 650 card would be right for that kit or should i go bigger? or smaller?