bending the brake lines for the nine inch now and was Hoping someone can help me with a picture of where the line unbolts from the factory rearend , to where where that is mounted when doing a nine inch swap .
I found the hole on top of the housing on the nine inch ( it has a vent tube there now) thought it would go there , but unless i change rubber line, the block just reaches that hole and leaves no play at all . How tight can it be ? Does that line need to be changed ?
I found the hole on top of the housing on the nine inch ( it has a vent tube there now) thought it would go there , but unless i change rubber line, the block just reaches that hole and leaves no play at all . How tight can it be ? Does that line need to be changed ?