12 bolt swap

[Wes]

I've taken them out by removing the rubber then use a sawzall to cut the metal sleeve just be careful not to hit the ear on the rear. Once the relief cut is there just bend it in with a hammer and then tap it out of the rear ear. Again be really careful not to go to far so you don't damage the ear.

 

[v8power]

if you can get the drill bit to catch around the metal part, you can walk the rubber part out in one piece, then a air hammer, or a sawzall and inch it together and pop it out. its defiantly not a fun thing to do.

 

[h2opunk182]

i ended up getting them out with a air hammer.. took about 10 min for both of them.. i ordered new break lines and fluid and will hopefully be doing the swap in the next week.. can anyone else think of anything that i will need while doing this??

 

[TNTS79]

rags...

 

[h2opunk182]

hahah thanks.. rags and gojo.. its like a 6 pack of sam adams, dont work on a car with out it!