Finishing up on a sbc 350 that has a mild billet roller Crane cam. Plan on running a Carter street type mech fuel pump.
This piece is going out of state and won't see it again for 10,000 miles, Was planning on using a Comp 4609 push rod that has the bronze tip but now there's concern about whether it will reach the 10,000 mark w/o losing fuel pressure due to push rod wear.
Does anyone have experience with longevity of these push rods? Is in necessary to go with a roller tip push rod?
Thanks for any responses.
This piece is going out of state and won't see it again for 10,000 miles, Was planning on using a Comp 4609 push rod that has the bronze tip but now there's concern about whether it will reach the 10,000 mark w/o losing fuel pressure due to push rod wear.
Does anyone have experience with longevity of these push rods? Is in necessary to go with a roller tip push rod?
Thanks for any responses.