69 chevelle w/ da control arms. I been at it , but not sure I have found a good point to measure off the frame.
Use a plumb bob off lca rear bolts, also used the center line of the axle flange for my rear measurements.
I have used the cross member under the motor & also various holes in the frame rails.
I have measured in a X from the frame holes to frame holes hoping to get equal measurements before tring to square the rear.
What am I missing??
Thanks
Use a plumb bob off lca rear bolts, also used the center line of the axle flange for my rear measurements.
I have used the cross member under the motor & also various holes in the frame rails.
I have measured in a X from the frame holes to frame holes hoping to get equal measurements before tring to square the rear.
What am I missing??
Thanks