all my people are at work and I need a quick help. trying to get my motor mounts off the cradle, and cant figure out how to get into the bolts in the cradle. do I go through the control arm pockets? how do I get in there to get them out?
pretty sure i just went through the little access hole in on the front side of the frame with a box end wrench. i tried going through the control arm hole with an socket on a swivel and extension and got tired of trying to keep the socket on the #### nut.
I enlarged the access hole in front of then upper two bolts to get in there easier. I went throught the lower control arm hole for the the bottom bolts. A piece of electrical tape on one side of the wrench keeps the nut from getting lost when you go to put them back in.
I can get my wrench on the back top bolts of the mounts through the whole but not the front ones. opening them up sounds like a good idea. I was hoping they would be like a gearbox or pitman or idler and have holes drilled big enough the get an extension and socket through but so far I haven't found any.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.