79' malibu project thread

r_d_3

Amateur Racer
Thread starter
Feb 25, 2020
121
67
28
27
New Jersey
drivers side frame notch, made a card board mock up wheel 15x10 5.5bs should fit just fine
IMG_2010.jpg
IMG_2018.jpg
IMG_2019.jpg
IMG_2020.jpg
IMG_2031.jpg
IMG_2032.jpg
IMG_2033.jpg
 

CosmoZL1

Daily Driver
May 29, 2018
47
41
18
San Antonio
  • Like
Reactions: r_d_3

CosmoZL1

Daily Driver
May 29, 2018
47
41
18
San Antonio
picked up my 10pt cage from S&W racecars on Friday, excited to get the body back on and start fitting this up.

View attachment 10976
Did you go with CM or DOM? I started with that same kit. Some my chassis builder used, some not so much. Will your rear wheels go under the fender? My problem is pulling the trigger on wheels. If those are 5.5 bs? Will they allow the car to sit level? Very interested. Thanks RD
 
  • Like
Reactions: r_d_3

r_d_3

Amateur Racer
Thread starter
Feb 25, 2020
121
67
28
27
New Jersey
Did you go with CM or DOM? I started with that same kit. Some my chassis builder used, some not so much. Will your rear wheels go under the fender? My problem is pulling the trigger on wheels. If those are 5.5 bs? Will they allow the car to sit level? Very interested. Thanks RD
The wheels on the car now are 15x8 4" bs, I'm planning on going with a 15x10 5.5Bs the quarter panel will probably need to be rolled, but I wont know for sure until I get the body back on the frame.
 
  • Like
Reactions: CosmoZL1

MalibuRacing.com Gear

Stickers & Shirts!!