Search results

I have a sbc 400 (bored. 30)406 with speed pro forged piston (part#L2489F) with sbc vortec heads on it now and will be swapping the 64cc vortec heads out to gm performance fastburn 62cc heads what will my compression be with the fastburn heads, block is stock deck using a. 39" headgaskets? THANKS

So there should not be any problems with running two different Vortec heads on the engine? THANKS

Can 2 different sbc vortec casting heads (906&062) heads be used on a engine a friend of mines has a running engine with 2 different vortec heads on it both heads had valve jobs on them before being put on will these heads work as they should?

I have seen several brand new transmission filter kits for GM 350 turbo Transmissions but they do not come with the little small gasket that goes between the filter and the transmission is this gasket required when installing a transmission filter or can I leave it out if so where can I purchase...

Okay Thanks i got it in put one upper and lower then other lower jacked up rearend and got the other upper.

I'm about to install a 7.5 positraction rear end in a 1979 El Camino is it best to attach the upper control arms first to the rear end when jacking the rear end up or attaching the lower control arms first when jacking the rear end up? THANKS

Is the g body El Camino driveshaft the same length as other g body cars when installing a 700r4 trans(49 1/2") long or is it a different length? THANKS

Okay Thanks

Zip tie maybe better for me also,so after.installing and bleeding cut.the zip tie and the pin will pop out and is that how you adjust the proportioningredients valve? THANKS

So will the pin pop out when I install the new one the pin is all the way in on the new proportioning valve? Thanks

I will be installing on stock brake proportioning valve on my 1980 Chevy Monte Carlo is there any special things I need to do or do I just on bolt the lines and the valve and replace the new proportioning valve, remove and install the lines or do I need to set anything on the new proportioning...

Okay I got offset /offset mufflers coming

I have a pair of Dynomax Ultra Flo welded mufflers (part#17219)offset inlets /center outlets will these Mufflers work on a G body or will I need different in and outlets? THANKS

Okay

So will the headers be ok to install without any leakage

I have a pair of Hedman headers for small block Chevy that has splits in the flanges in.between the tubes where the flange bolts to the heads will the splits in the flanges affect any performance or leak when the headers are mounted on the engine? THANKS

Okay and I will probably just take the old bushing

Okay Thanks

So measure the hole in the bushing or what

So whenever size open-end wrench fits that's what size it is like 15mm or 5/8? THANKS