Search results

How much nitrous can my engine and combo safely handle? 350 one piece 4 bolt mains Cast steel crank LT1 powder rods LT1 Hyper pistons with moly rings Vortec bowtie heads hydraulic roller cam - 108lsa [email protected] .530/.530 lift rpm air gap holley 650 dp Hei SFI flexplate 3000 TCI converter (no...

I'm having my th350 built to handle my new motor, approx 450hp. It will be behind a 3000 converter. Who makes the best kit to do a complete street strip rebuild?

Hey guys this video sparked my interest in a lenco: http://www.youtube.com/watch?v=2zAabHV-ftQ Also found this one for sale: http://www.racingjunk.com/post/1107847/LENCO-ST-1200-4SPD-TRANS-BRAND-NEW-.html any experience with these?

I put my new engine in: Its a ZZ4 shortblock: 4 bolt one piece rear Cast steel crank Powder rods 5.7" (ZZ4) LT1 hyper 4 valve pistons (ZZ4) (10.25:1 compression) Plasma moly rings Steel billet hyd roller cam: Bullet racing cams 530/530 lift 242/242 @ .050 on a 108 Ls1 Roller lifters Stock...

Hey guys i have a bowtie vortec headed 180cc, 10.25:1 compression, 242/242 @.050 530/530 108hyd roller, 350 chevy with an hei. Im gonna start it tomorrow, What intial timing should I run it at? I was thinking 14 for break in and 18 after? What total timing? I head the vortec like less...

If I want to run a 200 shot on a 350, should I run a 1 gallon cell with race gas and its own pump/reg to feed the fuel solenoid? Or is this overkill for a 200 shot. Could I just run 1 big electric pump and split it with 2 regs and 92? What size fuel line should I look to run? I assume if I...

Hey guys im looking to do a budget nitrous build. Im looking to do a 4 bolt 350 block with a cast steel crank, powder rods with arp bolts, forged speedpros, vortec heads and a flat hyd lunati nitrous cam. I want to run an NOS cheater setup with a 200 shot. If the motor is built for...

Are LS1 hydraulic roller lifters the same length as the rest of the OE roller blocks?

I recently purchased 2 weld draglites for my el camino. they are 4.5" back spacing and they are too close to the frame rail. I am purchasing 1/2" wheel spacers to make them fit. Will I need longer wheel studs?

Im looking to buy a set of 15x8 draglites with a 4.5" backspacing. I wanted to know if these will fit on a 1979 el camino? They are off of a 4 door malibu. Will i have any issues?