Gauge and Dash Delima

[35spline]

I have an 80 Malibu with a pretty nice dash and an Autometer Cobalt gauge set that came with the car. What I have is a 3 3/8 speedometer, with 2 1/16" "oil, temp, volt, and fuel.

I am going to pull the voltmeter and replace with an AFR gauge. I am looking for any ideas to get a a tach in there. I am not a fan of the pedestal mounted tachs. If I get a 3 3/8" tach I would have to get a 2 1/16" speedo and move one of the small gauges to the radio/heater delete plate I am working on. Anybody know of a decent 3/3/8" tach/speedometer combo?

 

[malicad]

Re: Gauge and Dash Delime

Sorry, but I had to, lol. This is mine...

https://rover.ebay.com/rover/1/711-...0001&campid=5338652022&icep_item=282159501857

 

[35spline]

I need to find the right gauges to fit in the current cut outs or find/fad a new gauge pod.

 

[blownbigblock]

I make dash inserts that would alow you to install what you want

 

[MalibuRacing]

You could locate a couple of the smaller gauges down on the right side of the column like I did:

 

[bmfmalibu]

How do I get one of those blown big block im in Michigan also

 

[82wagon]

I'm searching for a gauge bezel currently but when I get one I may be interested as well.

 

[dirtymax6489]

x2 blownbigblock...I live in battle creek mi

 

[35spline]

I decided to to keep all of my gauges and just move some of them to the center of the dash. I made a radio/heater delete plate and placed three of of gauges there. The EFI Source Gold box ecu is mounted directly behide the plate. Keeping the current cut out holes I added boost/vac gauge, a digital RPM gauge, and installed the gauge that came with my AFR sensor.