I just got my truck harness in the other day. Red/Blue harness
Got the engine out, removed the factory computer and all the wiring that went with it through the firewall. Only have the A/C stuff left over on the passenger side.
Driver side I got the wiper motor off and removed the connector from the fire wall that's for the engine & front head light harness
Been working on the truck harness a bit this morning and got all the tape/wire loom removed and majority of it labeled so I know what goes where.
I also have a print out of this from lt1swap..... http://lt1swap.com/99-02_vortec_pcm.htm
(plans)
Keeping it EFI obviously
5.3L Drive by cable
4L60E
All Auto meter guages or Might go Dakota Digital (undecided)
Want to setup a light for check engine
Should I just be following the link from lt1 swap and remove all yellow highlighted wires? and NOT touch anything highlighted in red since I'm keeping the 4l60e?
Got the engine out, removed the factory computer and all the wiring that went with it through the firewall. Only have the A/C stuff left over on the passenger side.
Driver side I got the wiper motor off and removed the connector from the fire wall that's for the engine & front head light harness
Been working on the truck harness a bit this morning and got all the tape/wire loom removed and majority of it labeled so I know what goes where.
I also have a print out of this from lt1swap..... http://lt1swap.com/99-02_vortec_pcm.htm
(plans)
Keeping it EFI obviously
5.3L Drive by cable
4L60E
All Auto meter guages or Might go Dakota Digital (undecided)
Want to setup a light for check engine
Should I just be following the link from lt1 swap and remove all yellow highlighted wires? and NOT touch anything highlighted in red since I'm keeping the 4l60e?