Search results

What I do lay down some cheap lacquer guide coat on the areas in question. Block them out to get rid of high/low spots. Use as long of a block as you can and you'll get it straight.

You can use stock hinges, just pull off the springs. You will need a prop rod of some sort too.

It can be done but is a bit of a process. First you have to take the interior trim from around the window off, and you will find two nuts holding on the exterior trim on. Remove that and the window. now you will see a spot welded extension piece , drill out the spot welds and you will be left...

yes and yes

I have 15x7 on all four corners with 235/60/15 front and 255/60/15 in the rear and nothing rubs.

Valspar owns house of color and thay have some good stuff.

Alot of it depends on how far you want to go with it, what type of paint, existing paint condition that is on it and if your changing color. I assume we are talking about your Cutty, If the paint isn't pealing I would block the car down to get rid of any waves, then if straight take it down to...

sure, that will be fine.

A 350C will have a electrical connector on the drivers side just above the pan

you have a PM

willing to sell the posi?

you have to pull it apart , the shaft is the first thing to go in and the last to come out.

lots of guys have this problen 90% of the time you need to reseal the A/C heater box .

no there sealed you should be fine.

those won't raise the rear of the car, they are used to keep the spring from compressing

Last weekend i dropped in my new GMPP 290 hp engine. got everything together and it had a tick that starts around 1500 rpm ](*,) but is not there at idle. I tightened down the headers and that helped some, but the tick is more pronounced at the front of the engine. Pulled the V/C the tired to...

Yes sir

You didn't by chance get 78 rotors did you? They have a smaller outer bearing thatn 79 and later.

First we need to determine what transmission you have. A th200 will have METRIC stamped into the pan , has no vac hookup and has a one piece case. TH350 has pan shaped as stated above, a vac modulator on right rear that's hooked to manifold vac and a cable for kick down. Th400 has a odd shaped pan...

:shock: Dang dude you're pullin' out all the stops ! Can't wait to see the finished project! =P~ =P~ =P~