What did U do to your G-body today??

[beefcurtains]

Got the rearend,coilovers,and ARB mocked up over the weekend,also started the frame notch.

 

[kuruption109]

got these parts from my club brother for my malibu

[

Holley 4150 600cfm single inlet setup off my GMP crate motor. Lil polish and it will shine up nicely. I just threw the water neck on there for the pic..

Gettin her "DIGITAL READY" :mrgreen:

 

[malibu795]

goign to be working on the exhaust again.................. :|

 

[SLICK78]

Wow, talk about work... Pushing that car around the neighborhood must have been fun....

lol not really I only had my wife and 8yr old boy to help... coming out of the garage it jumped a 4x4 and almost hit the wifes new car ooops lol

 

[454RAT]

Getting ready to swap the converter and also re-do the brakes. Hoping to get some more runs in this month. Looking for low 6's in the 1/8 on E-85.

 

[80Grand_LeMans]

Finally finished building my olds 350. 330 heads, edelbrock cam, lifter, timing set and intake; comp roller rockers and pushrods, and full length headers. have to wait until tomorrow to break it in. Gonna be loud!

 

[Wicked 6]

Change the rear springs car dropped almost 1 1/2"...was going to lower the front but figured when the big block goes back in it'll sit just right. Found one of the trans mount bolts loose and it won't tighten so will deal with that tomorrow.

 

[1980PontiacWagon]

Went racing for the first time today....car deffinatly needs some tuning, runs super rich, plugs are black...need new tires (They are 10 years old)

Best run was:
60 foot: 2.050
1/8: 8.527
86MPH
Hopefully next week I can get her running a little better...and work on that 60FT time lol

 

[kuruption109]

before engine degreaser

after

some rust issues i see so far but i dont care im focused on gettin drivetrain right

few before pics of when it was dirty.. driver lower door panel was in the back of the wagon...

after some trash was removed..still needs vaccum and carpet cleaned

 

[Brown_Gbody]

K; when did you get a wagon???? Hows the engine swap coming???